Crank Brothers Iodine 11 Carbon Riser Bar
Exactingly made from high modulus, unidirectional carbon fiber, the Iodine 11 sits at the top of Crank Brothers' new range of Iodine handlebars. Just a few grams heavier than the XC-oriented Cobalt 11, the Iodine 11 is beefed up where it counts to make it suitable for all-mountain use.
The oversized clamp area is coated with special non-slip material and has very wide adjusting scale to ensure precise placement. Additionally there are measuring scales to line up your levers and four cutting guides in 1cm increments per side should you want to trim down the width.
The Iodine 11 is reinforced for bar ends. Please be advised that it's only bar end safe in its "natural state." If you trim down the bar, you'll be cutting out the bar end reinforcement.
As with anything carbon, be sure to use a torque wrench for proper installation.
|Material||High modulus carbon|
|Sweep||Back: 6 degrees, Up: 5 degrees|